Electronics Forum | Fri Sep 23 10:11:17 EDT 2011 | patrickbruneel
Oswaldo, Your reasoning is correct, but the strange part is that Russ didn’t have a problem for years using the same flux so you would assume his fluxer is designed for low solid fluxes.
Electronics Forum | Fri Oct 11 17:05:32 EDT 2013 | hegemon
Just a thought... At that scale you might try to print paste on the devices and reflow to make bumps. That combined with your paste on the PWB might be sufficient. 'hege
Electronics Forum | Fri Oct 11 17:10:36 EDT 2013 | hegemon
I think the critical item is that you are soldering in a reduced oxy environment, lowering the rate of ongoing oxidation. Heat accelerates oxidation, lack of oxygen (of course) slows it down. The 10 Nitrogen soldering "myths" seem to be more like "
Electronics Forum | Fri Oct 11 17:19:23 EDT 2002 | peterson
The ASG (Tyco) MEP (Manual Electric Press) or the AEP (Automatic Electric Press) are both excellent machines, we have used them successfully on all types of press fit connectors. Give Dante Parenti a call and he can help you out. (215) 784 4530 Or g
Electronics Forum | Mon Oct 11 17:14:30 EDT 2010 | markhoch
I've had this problem before. Typically happens when the Lithium Battery dies and the machine loses the program. Usually you can pull the displays out and ship them to Simplematic. They can reload the program for you. Roughly $2500 bucks I think. Cal
Electronics Forum | Thu Oct 11 17:15:31 EDT 2012 | boriskilk
We have seen two issues which have caused problems with solder mask adhesion. The first was improper curing of the mask but also solder temps which were too high, particularly with a white tin finish. Rather than tell your supplier their material i
Electronics Forum | Mon Oct 11 17:15:03 EDT 1999 | Mike H
| Just curious as to everyones thoughts on if you could chose to use F4G or an MCS-30. Which would you chose and why? | | | Larry J | |Larry, depending to your Fuji machines, if you are using any new machines like QP1 or QP2 and any other ones li
Electronics Forum | Wed Sep 16 10:11:17 EDT 1998 | Ben Salisbury
| Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appre
Electronics Forum | Fri Oct 11 17:30:37 EDT 2002 | peterson
Ok, I can't resist. I agree that a rep should be allowed to contribute if he/she identifies themselves. There will always be a conflict between technology/information and sales. Here's another example. If you are reading say, Circuits Assembly or SMT
Electronics Forum | Thu Oct 11 17:54:21 EDT 2007 | slthomas
Yep, we did it just the way you described, I think. What we did NOT do was a block conversion. We just built it a board at a time, to see if things were accurate when we first programmed it. They weren't, so we did away with the block fids, adjusted