Electronics Forum | Thu Jul 26 22:56:03 EDT 2007 | davef
And they're using a stencil that is how thick?
Electronics Forum | Wed Jul 25 10:57:08 EDT 2007 | cecil
Our board layout folks are currently designing a PWB using a 132 QFN. The component is .5mm pitch with .35mm square pads. The component manufacturer recommends the following footprint: .4mm square land .3mm square solder resist 1.why do they spec
Electronics Forum | Mon Sep 03 10:50:47 EDT 2007 | kissanepat1
A suggestion for your stencil which works is as follows. Cut your stencil aperatures beyond your pads to a length of 0.1mm , this then allows the paste to pull back into the pad creating a blob of solder which can be inspected by AOI.Best length and
Electronics Forum | Thu Aug 16 09:42:15 EDT 2007 | russ
This could be the reason for the mask defined pad. ERROR in docs! This happens a lot. I believe this to be case honestly, I would not use mask defined pads for these. If you get a registration shift in mask which is likely you will run into troub
| Sm | t | net |
| 1 |
.gif)
winsouce.jpg)