Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Electronics Forum | Thu Aug 17 09:57:16 EDT 2006 | jwn
Hi all, I need to find a solution for a problem I have. I need to replace BGAs which have been glued to a laptop board with superglue (Loctite). How can it be done without removing the pads when trying to remove the foreign glue? thanks in advance
Electronics Forum | Sun Jun 05 13:42:16 EDT 2005 | amigo
We find it impossible to remove the glued micro-BGA chips like the CPU and the UEM ICs used in Mobile Phones. They are both surface mount devices and glued with some chemicals we think. Any help is most needed in this matter.
Electronics Forum | Fri Jul 20 17:09:10 EDT 2001 | davef
Circuits Assembly magazine 09/99 "Defluxing with Ultrasonics" by Les Hymes. [There's more but I can't find it right now. I'll add to this as I find the junk, er very nice stuff.] J-STD-001C states that its OK to use ultrasonics for cleaning so lon
Electronics Forum | Wed Nov 08 05:19:28 EST 2006 | amigo
It's not underfill is it? Sorry, but i don't know what is underfill, if you mean BGA, yes it is BGA !also sorry for very very late reply
Electronics Forum | Thu Nov 29 13:22:39 EST 2018 | roblackey
Hi Evtimov, For BGA's you place 4 on each side right outside the edge balls and it pulls the case down and a bit is pulled between the balls on reflow. Not tried gluing a crystal (they only gave me a strip to play with)
Electronics Forum | Thu Jun 01 21:14:21 EDT 2006 | roadhound
Hello, We repair mobile (cellular) phones, and most are now having their u-BGA IC's underfilled. Can anyone suggest methods for removal of the IC's ? The manufacturers are very vague when it comes to this process, but are starting to get tired of u
Electronics Forum | Thu Dec 15 04:26:20 EST 2005 | Rob
Hi Liza, We tend to see it on the larger plastic tape sizes & lower volume parts - such as smd connectors, fine pitch reeled IC's, BGA's etc. We don't tend to get it on high vol parts such as logic, 8 & 16bit micros, v-regs etc. Could this be du
Electronics Forum | Wed Jul 24 23:21:26 EDT 2002 | ppcbs
Being in the line of BGA rework and having performed much rework on boards that go into military planes, I can give you an opinion from a practical background rather than an in depth study. Basically BGA's have caused many of my customers big headac
Electronics Forum | Tue Oct 30 06:20:58 EDT 2007 | aj
Hi All, I would appreciate some advise with regard to Leadfree settings for a 5 zone reflow oven. I have a 35mm square BGA 672 pin on board. I am struggling to get the Delta T down to 2 degrees C . I have 5 Thermocuples drilled up from the bottom a
winsouce.jpg)
