Electronics Forum | Wed Nov 18 12:56:06 EST 2009 | evertonsanches
Hello I had similar problem on VIP 70A. Try to check auxiliar contact from located into front panel. Everton - BRAZIL
Electronics Forum | Mon Apr 12 09:13:45 EDT 2010 | toddl
Check your "over temperature module" for both top and bottom zones when the alarm is active, there is a bank of LED's on the bottom of this module. Monitor it to find out if the same zone keeps activating the alarm, if so check your TC for that zone.
Electronics Forum | Wed Apr 19 16:28:05 EDT 2023 | previnmoore
I need to replace the chain for the drive chain tension and i cant figure out the size. Any help would be appreciated thanks
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Wed Feb 21 17:27:02 EST 2001 | jollyrodger
HELP...... I have recently taken on the post of line technician at my place of work. I require as much information as you can give me on all SMT processes. We work with Fuji CP643E, Philips FCM, Dek 265, Universal GSM, BTU Paragon ovens. All infor
Electronics Forum | Tue Sep 16 10:14:03 EDT 2003 | mantis
James, Could it be the convection in the reflow oven itself.Maybe somebody has increased the air flow or convection rate. I have seen an issue with an sot23 blowing off pad in a BTU paragon due to air flow in air curtains being too high. Hope this h
Electronics Forum | Thu Sep 15 13:52:40 EDT 2005 | pr
We had 2 at my last company. As I recall we had a hell of a time with bad blower motors. I'm not sure how you'd check on that, but maybe that problem has been fixed by now (it's been a few years). good luck, pr
Electronics Forum | Mon Oct 17 09:53:58 EDT 2005 | rlackey
BTU have been around since the start of SMT, with ancient TRS14's still running today with no problems, and bucket loads of VIP's, Paragons & Pyramax's doing good service. Wouldn't use anyhting else (Did like the new Vitronics-Soltec, but couldn't b
Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Fri Oct 01 04:31:08 EDT 2004 | pioneertechnology
Hi Marcel I bought four BTU ovens a couple of years ago at auction and had the same problem where two of the ovens had software and two did not. I loaded in the software I had onto the two ovens and this only partially worked as the software is con