Electronics Forum | Mon Jul 14 12:55:07 EDT 2008 | arminski
I have a board with the above problem from our PCB supplier. After they applied the solder mask and run the PCB's to HASL process, the solder mask bubbled on one side of the PCB making the solder mask thickness higher and PCB looking awkward. They s
Electronics Forum | Tue Jul 15 17:54:57 EDT 2008 | arminski
thanks sir! you explained it very well.... thanks a lot!
Electronics Forum | Wed Jul 16 19:07:59 EDT 2008 | boardhouse
Your Welcome.
Electronics Forum | Tue Jul 15 16:12:23 EDT 2008 | boardhouse
Hi Armynski, I sell for an offshore board house, yes, it is common for offshore board shops to fill vias. The bubble is caused by air entrampment within the hole it self, when heat is applied during Hot air and the via is covered on both sides the e
Electronics Forum | Tue Apr 04 10:18:58 EDT 2000 | Russ
Brian, I agree with Jesper, You seem to have a PCB supplier problem! The conditions that you are processing your assembly with are nothing unusual and in fact very standard throughout all of the manufacturing facilities that I have been in, unless
Electronics Forum | Tue Apr 04 04:55:31 EDT 2000 | Jesper K
It's a typical answer from a board fabricator - 'None of our other customers have these problems'. But, and correct me if I'm wrong, none of the other customers uses the same PCB's as you do! Your preheat-parameters looks OK - they should not be giv
Electronics Forum | Fri Dec 10 06:06:54 EST 1999 | Wolfgang Busko
Hi Glen, looks like flux or solder mask problem. In your first mail you said that only some boards show these symptoms and others not. First I would check on the differences between those Boards, manufactorer, solder resist, contamination. If that d
Electronics Forum | Wed Feb 03 04:44:43 EST 1999 | Jeff Sanchez
| | | Hello Netters, | | | | | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that t
Electronics Forum | Sun Jan 31 22:55:33 EST 1999 | Dennis O'Donnell
| | Hello Netters, | | | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
