Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Industry News | 2009-12-08 14:59:47.0
Reinhausen Plasma will be at the productronica where it will be presenting the world’s very first process for chemical-free and energy-saving metallization and coating for a multitude of different materials - its nano-powder deposition technology, Plasmadust for short.
Industry News | 2019-11-05 22:26:14.0
The board stack-up is probably the most essential piece for ensuring a successful PCB design. Modern high-speed boards require controlled-impedance traces, and whether you are using a simulation tool, a simple calculator, or the back of a napkin, you need to understand your manufacturing process to correlate your impedance calculations. This ensures that your trace widths and dielectric heights match what will actually be manufactured, and eliminates last-minute design changes.
Electronics Forum | Wed Oct 16 01:28:45 EDT 2002 | redmary
during the failure analysis, how to etch the tin,nickle,and copper?
Electronics Forum | Thu Oct 17 23:25:53 EDT 2002 | redmary
We generally etch the copper back slightly using a 50/50 mix of 3% Hydrogen Peroxide and laboratory grade Ammonium Hydroxide. Swab for about 5 seconds, then rinse. and etch the tin in the solder to further delineate the intermetallic layer that shou
Electronics Forum | Thu Nov 16 06:13:16 EST 2000 | Adam Seychell
I am currently building a home PCB etching tank based on the ammonia/ammonium sulfate chemistry. The etching system consists of a etching tank, and an electrolytic copper recovery tank. The result is a infinitely replenishable etching system without
Electronics Forum | Wed May 14 13:31:22 EDT 2014 | taiji
You should look in to this document: IPC/JEDEC-9704A Printed Circuit Assembly Strain Gage Test Guideline Regards
Electronics Forum | Thu May 15 17:34:17 EDT 2014 | taiji
I always made tests with gauges on top or bottom surface of the PCB, before, during and after the process that we wanted to check. But I never tried to do it on internal layers of PCB. Don't know if that is possible. Regards
Electronics Forum | Thu May 15 09:55:16 EDT 2014 | julianf
Tmo, Thanks for your reply. It gives good advise about how to perform tests. The type of strain gauges that I want to design are inside the PCB at various layers and I want to read the data during the press step. Do you know if these prefabricated
Electronics Forum | Fri May 16 05:17:13 EDT 2014 | julianf
Interesting. How did you connect the gauges in the press? Our press only has connections for thermocouples. But in essence, it's only a wire and an electical output. If you placed these prefabricated gauges on top and on the bottom surface, weren't