Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
Electronics Forum | Mon Feb 01 14:04:12 EST 2010 | bing007
Found the problem. Thanks for the pointers. I had set the voltage to 5.00 volts as it was reading 4.86 volts. I still had the problem. A slghtly burnt wire going into the spade connector on the back of fuse holder 12 (5 volts). The reason the voltage
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai
Electronics Forum | Tue Aug 20 12:37:48 EDT 2024 | ttheis
Well it rarely fails that I post here and resolve the problem shortly after. I noticed the "PelSizeY" value was in the hundreds instead (188) of tenths (0.155) which indicated some issue with Y calibration. This coincided with the alignment issue-
Electronics Forum | Wed May 16 18:09:09 EDT 2018 | dleeper
Does the table move under the stencil than just sit there doing nothing? there is an optical sensor in the machine near the end of travel, sometimes solder past or dirt gets into it preventing the contact from being made. Another issue I vaguely rec
Electronics Forum | Sun Dec 26 16:13:49 EST 2010 | sam
Hi, Here is a brief synopsis of PNC - PNC has been a quality manufacturer of rigid printed circuit boards for 40 years. Located in Nutley, NJ, we are the largest shop in the North East. PNC provides complete turnkey jobs from design, PCB fabricatio
Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Tue Jun 08 12:49:41 EDT 1999 | Dave F
| Hi,my master | How to iron out such soldering bridge with below conditions: | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | 3.using spraying fluxer and n
Electronics Forum | Tue Jun 08 14:16:49 EDT 1999 | Dave F
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav