Electronics Forum | Tue Jan 05 07:48:39 EST 2021 | mbass
Go for Gen 2 NT feeders, the Gen 1 Feeders tend to be problematic the older they get whereas the Gen 2 feeders are a much better prospect. I've used 8, 12, 16, 24 and 44mm. Some problems to look out for is pull back of coverlay and removal of waste
Electronics Forum | Mon Mar 08 04:51:43 EST 1999 | John Godfrey
| We are currently looking into purchasing a high volume, medium mix production line. We are considering several different vendors and I would like to know if current users of Siemens equipment are happy. Are the machines maintenance intensive? Ho
Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |
Electronics Forum | Sun Feb 06 15:38:39 EST 2005 | Grant
Hi, I think we would get a jam up every hundred parts or so, and it's worse in cover tape that's glued down. The problem is the Agillis feeders push the cover tape to the side, which works ok on 8mm tapes, but on wider 12 and 16 mm tapes it's a nigh
Electronics Forum | Wed Jan 02 12:15:44 EST 2002 | pteerink
Don't waste your money on T&R feeders for large parts. I used to have an old TP9 and we ran tons of products with vibe tubes and odd shaped parts. Used to cut our own tubes for parts and jimmy-rig parts like crazy to make them all fit on the machine
Electronics Forum | Thu Mar 24 17:36:31 EST 2005 | Grant
Hi, Yes MYDATA vibration feeders are a nightmare, but you might want to check the feeder. We had one that would vary a lot, and it never seemed to be able to be set to the right vibration level for consistent feeding. It turned out to have a problem
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
