New Equipment | Cleaning Agents
LONOX® L5611 is a solvent-based cleaner for misprinted boards and stencils. It is effective on a wide variety of flux, solder paste and uncured adhesives. Easy to use, L5611 is intended to be diluted with water and effective at ambient temperature t
Used SMT Equipment | Soldering - Wave
Technical Devices NU/ERA 16MP (EXCELLENT CONDITION) L and V fingers Internal 9500 spray fluxer dual wave Full of Sn63/Pb37 solder finger cleaner top side tunnel roll out solder pot Like new condition
Used SMT Equipment | Soldering - Wave
Model Specifications: Date 12/98 440 Volts Three Phase 46 KVA 60 Hz 20" L/R N2 Rotary Chip Contour Bar Feeder Exit Photo Eye Light Tower 3 Bottom Vectra Heat VVL Intermix 3.0- 1/16" fingers Ceramic Aerators 12" Load Guides Finger Cleaner
Used SMT Equipment | Soldering - Wave
EPK Wave Soldering Machine, L to R, V finger, Foam Fluxer, 2 bottom covnection, Lambda Nozzle and Finger Cleaner, 1996, 480 3 phase, good condition. Can be sold as is or refurnbished. Currently 100% operational. Owner was using SN100c alloy. Loca
Used SMT Equipment | Soldering - Wave
Electrovert Econopak I SMT, 220VAC 3 phase, recently decommissionel. L to R Board Flow, V fingers, Foam fluxer, Two bottom side IR preheaters, One Top side IR preheater, Lambda Wave, Omega, Finger Cleaner. Manuals. Extremely clean, very good co
Used SMT Equipment | Soldering - Wave
Very clean machine, appears to have low hours. Has Selecta Spray fluxer, 18 inch finger conveyor with a mix of L and V fingers, center board support and finger cleaner. Six feet of preheat, Solder pot with Lambda and turbulent waves. Pot full of 1600
Used SMT Equipment | Soldering - Wave
Vitronics Soltec Delta Wave 6622C, Manual in-feed slides, finger cleaner, Heavy Duty Transport Fingers, Finger Crash Detection, Light Tower Single Spray Nozzle (Beta Fog Nozzle 3.7), 2 Bottom Convection, 1 Bottom Cal Rod Heater, 1 Top side IR Heate
Introduction to the Unitech UC-250M-CV PCB Cleaner. Multi-stage in-line bare PCB surface cleaner. Brush/vacuum, rubber roller/sticky paper, & Ionized air blower.
Introduction to the Unitech UC-250M-CV PCB Cleaner. Multi-stage in-line bare PCB surface cleaner. Brush/vacuum, rubber roller/sticky paper, & Ionized air blower.
ATRON® SP 200 is a water-alkaline surfactant cleaner, specifically developed to remove baked-on fluxes from solder pallets and condensation traps. ATRON® SP 200 can be used for the removal of unsoldered solder pastes from SMT stencils. The cleaner ca