Used SMT Equipment | Turnkey Lines
Functional Pre-Owned Complete SMT Assembly Line - Still Operational (Subject to prior sell, I am listing this on other venues) Up for sale is a full turnkey SMT line and all of it's accessories, of which there are a lot, fe
Electronics Forum | Fri Sep 23 09:53:33 EDT 2005 | PWH
Thanks all for the opinions. Our shuttle/GSM1/PTF install was done by an ex-UIC engineer. Have never utilized shuttle so appreciate the advice on pros and cons of it all. We have 1.0 mil on PTF side and 4.0 on shuttle side. C4 head on both sides
Electronics Forum | Thu Sep 22 18:15:51 EDT 2005 | PWH
Does anyone have experience using a shuttle on a GSM platform? I'm just wondering how well it works and how reliable and trouble free the component picks are. I am looking to run a low volume line with a printer/oven and a GSM1 platform with a PTF
Electronics Forum | Fri Sep 23 23:21:53 EDT 2005 | Mats
Please explain Your line configuration needs or the volume by: components/panel/day/operators(people)/investments/yield/customer requirements/Your own req./etc. that You need. In Your initial thread You said that You had a low volyme production and
Electronics Forum | Sun Jan 24 08:48:43 EST 2021 | dilogic
GSM's have MMIT I/O bus. It is used for most of the discrete I/O, so I would check it's operation first - see attached diagram. You sholud have BUSPROBE tool which you can use to read/write memory locations directly. I do not know if you have access
Electronics Forum | Wed Oct 13 05:43:50 EDT 2021 | sophyluo1985
I have found it for you
Electronics Forum | Mon Oct 13 18:10:30 EDT 2014 | ilavu
Hello, I am looking for the backup (mapping and calibration) of Universal GSM2 with both beam with Flexjet head. I am having problem with placement from beam2 is randomly off. Either X, Y or theta. Beam1 is placing all the parts with no problem an
Electronics Forum | Tue Oct 26 05:12:10 EDT 2021 | dilogic
Sorry, I attached the wrong file. EXM settings are explained in this one. No need for installation discs.
Electronics Forum | Wed Oct 13 15:41:31 EDT 2021 | dilogic
Aside from BIOS settings for the drive, there's another page with EXM settings (that's the interface your EXM-9 board is using). You have to configure it right in order to get the system running. See attached document where settings are explained - r
Electronics Forum | Tue Oct 26 20:02:48 EDT 2021 | astarotf
Yes Deni, we just found the battery on the EPC-5A board. I was wrong, because of my ignorance. We have the EPC-5A board, this one allows us to have a larger capacity disk, currently we have a 1705 MB seagate I hope after mounting this battery to be