Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Fri Sep 02 07:38:13 EDT 2005 | DannyJ
Hi Mike, I haven't tried the 0201s with a Hyrda, but after seeing 20 reviews of your message without a response, I'll try and share my experience with 0402s on a non-Hydra machine. The 0402s are slow, but I managed to get some speed by maxing out
Electronics Forum | Wed Jul 05 01:22:29 EDT 2006 | grantp
Hi, When I started out and we were the same we got an old MYDATA TP9-2U. It places everything, and you should be able to get a cheap one second hand, that will perform very well. They have vision as well, as an options, and that works very well. I w
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963
Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Wed Apr 26 14:06:46 EDT 2006 | mdm4ua
Hi JEM, We just made the very same upgrade you are looking to make on three machines. We purchased a new MY12 and upgraded our other three (My9 W/hydra, My9 No Hydra, and TP9-2U) from 2.2.4C to 2.4.4c. There are several changes and most of the