Parts & Supplies | Pick and Place/Feeders
BUSHING CUTTER 45744401/43871702 DOWN STOP BUMPER 45284801 TIP DRIVER J/W LEFT 43077104 BLADE SHEAR LEFT STD 45592701 BLADE SHEAR LEFT STD 12521000 BUSHING BALL 12539000 PLATE GUIDE 15308000 SENSOR INDUCTIVE 44460003 DRIVER TIP LEFT
Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Electronics Forum | Fri Jan 06 08:28:47 EST 2023 | peterm
That's really up to you and for DTF what bank you're using it in so you can reach the pockets for teaching. Obviously easiest to keep them all the same.
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Fri Nov 09 14:42:08 EST 2001 | vickt
Great advice!........Single tier feeder set-up carts are also available through Universal instruments directly for this exact purpose. Most people who really care about this changeover time have "pit-crews" that work in the component storage areas, o
Electronics Forum | Mon Jan 29 15:21:56 EST 2007 | flipit
If you teach your feeders, you can no longer gang pick correct? I have never had a dual beam or dual head GSM before. However, if you teach feeders with the fiducial camera and your picks are still off, there is an offset in one or several spindles
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Thu Sep 27 16:21:03 EDT 2007 | adlsmt
We have two, about 2.5 years old and 1.5 years old. We run all kinds of parts and get about 18K to 20K CPH. The pick accuracy is fantastic so have saved a lot of $$$$ by not having dump buckets full of parts at the end of runs. I could not be happier
Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
.gif)
