Electronics Forum | Fri Oct 04 11:46:31 EDT 2002 | mzaboogie
Hi Dave, No we are placing these parts on hard boards. Thank God! Thanks Chris
Electronics Forum | Thu Oct 03 15:14:46 EDT 2002 | SMTGuy
Good Day Everyone, Can anyone offer any advice on 0201 aperture design? We are looking at an application that will require them. We would like to do some experimentation first. Also, assuming an OA flux, would we need a type 4 or 5 powder paste to p
Electronics Forum | Thu Oct 03 18:45:56 EDT 2002 | davef
Get started with an "On-Board Forum" [blue bar an inch down from the top of the page] moderated by Jeff Schake at DEK that was a discussion focused on stencil printing issues with 0201 technology. Chris: Are you putting 0201 on flex? If so, sounds
Electronics Forum | Sat Oct 12 05:05:09 EDT 2002 | Kenture
I run 0201 on a 5 mils stencil with openting of 15X12 and did not have any issue. The major concern is the placement and CP643 did very good job. Type 3 solder pastes was used. Good luck.
Electronics Forum | Fri Oct 04 11:25:49 EDT 2002 | Bob Willis
If you want some additional material on 0201 design and assembly the SMART Group Committee produced one of its Charity Reports with all the money raised going to the Red Cross USA September 11th Appeal. You can get it from the SMTA Main office, it fe
Electronics Forum | Fri Oct 04 01:18:27 EDT 2002 | sarge
1.5. Width >= 4-5 Particle Diameters. Use the smallest opening to determine this. Using dimension of the smallest aperture width, you should be able to fit minimum of 4-5 solder balls side by side into the opening. For 0201 design, -400 mesh (type
Electronics Forum | Thu Oct 25 14:16:43 EDT 2007 | jsloot
Is anyone able to help me out on a typical aperture design for a castellated lead.
Electronics Forum | Thu Apr 12 09:13:41 EDT 2007 | aj
Hi all, What stencil aperture designs do you use for 0402 components? Thanks in advance for replies. aj...
Electronics Forum | Thu Oct 25 14:18:16 EDT 2007 | jsloot
Is anyone able to help me out on a aperture design for a lead free castellated part? please contact me if you can.
Electronics Forum | Tue Apr 17 17:30:09 EDT 2007 | jaimebc
Our experience with leaded paste and SAC305, for 0402's, has been positive with the following stencil designs: 1.- 5 mil thickness. 2.- Home plate design. Hope it helps.