Electronics Forum | Thu Oct 20 23:19:09 EDT 2005 | Cmiller
You should not be worried about these points in the SMEMA standard. You need to make it work for your application. If you are running really small boards, keep the gap between conveyors and the lead-in as tight as you can. If you are using large pane
Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Fri Nov 04 20:25:47 EST 2005 | mika
Always happy to share information. Perhaps other viewers on this thread, can get some ideas of "how to". /Sincerely Ps. There is a so called "standard height" which the conveours/machines from different manufactories must be able to reach; without r
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Wed Dec 30 11:10:53 EST 2015 | ilavu
Tom, Mount one sensor at about 6 inch inside of the beginning of the oven conveyor and use its output as ready to accept the board signal. That 6 inch distance will give you timing and space between two boards entering in the oven. Tushar
Electronics Forum | Wed Jul 19 20:24:41 EDT 2023 | ttheis
Conveyors are connected to machines with SMEMA cable interfaces; any edge conveyor manufacturer will have this interface.
Electronics Forum | Mon Jul 20 11:46:18 EDT 2009 | msherwood
I’m having trouble with the transfer of one board from the UIC conveyor to a DEk screen printer. They are set up for SMEMA to SMEMA but the DEK keeps asking for a aboard when it already has one. Then it will ask for one every 5-8 seconds. DO I have a
Electronics Forum | Tue Aug 17 01:03:21 EDT 2010 | dan_ems
Hello, If you have a conveyor at the output of the pick and place machine with SMEMA comunication between CP20 and the conveyor you must have check it SMEMA in setup (Sys Setup / Preferences)like in the picture. If you dont have this type of convey
Electronics Forum | Sat Jul 25 20:53:14 EDT 2009 | mika
Author: Jeff Subject: DEK SMEMA to UIC Conveyor Instead of using a conversion box just make your own cable. Look in the Dek manual, volume #2, chapter 18. It shows you how it's wired. Easy to make and looks allot cleaner than those conversion box
