Electronics Forum | Wed Jul 18 10:23:26 EDT 2007 | hussman
Check the fine archives or click here: http://www.smtnet.com/forums/index.cfm?fuseaction=search_submit&collection=site_industry_directory&searchstring=custom%20feeder The major placement companies MAY work with you on custom feeders, but it is very
Electronics Forum | Tue Oct 12 13:40:14 EDT 2004 | Jimmy
We recently went through an evaluation period of an NXT modular setup. We ended up purchasing the 2XM6 setup mainly due to the board length limitation of less than 10 inches for the M3 modules without splitting feeders. The machine has been extremel
Electronics Forum | Fri Jun 10 06:52:54 EDT 2005 | mmjm_1099
This sounds like exactly what I am going through here. If you come up with a nice solution please post it. One of the things I have done is make top and bottom programs similar as possible. No I didn't say all programs the same overall just each job
Electronics Forum | Sun Dec 04 15:48:25 EST 2011 | ngineer
I would like to get some parts for my Quad IVc, but it seems the prices of feeder bases / feeders / vib feeders are more than the machine cost me, so I was wondering if anyone on here had extra or spare parts that they would like to part with. I'm g
Electronics Forum | Wed May 25 10:01:59 EDT 2016 | stevedc
I tend to get issue on and off with the feeders either stalling and/or running slow/noisy. They are actually pretty easy to clean and maintain. If you take off the side panel of the feeder you will see a few gears, belts and a motor. The first thin
Electronics Forum | Thu Aug 10 16:34:18 EDT 2017 | kalsi311
Thanks for quick reply We were using 2 MR40LS machines and 1 MR20LP machine. MR40LS machine have tow beams and 12 heads (6 heads each) and MR20LP have 4 heads. In my new company we are using 2 lighting head who have 30 heads and 1 7 heads machine. B
Electronics Forum | Sat May 10 12:58:33 EDT 2003 | stefwitt
I find 100 feeder slots of 16 mm width quite sufficient. If there are two feeder tables, each table is ~ 36� wide. Even slow machines can travel that distance in less then 1.5 seconds. If I further assume, that an optimized set up may save 30-40 % o
Electronics Forum | Sat Jul 03 01:09:29 EDT 1999 | DEAN
| | I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/chan
Electronics Forum | Mon Jul 30 15:28:25 EDT 2007 | gmoritz
I'm posting a diary of the major repair experience that we had this weekend. I'll follow up with a shorter post that sort of summarizes a few things. ------------------------------------------------ The service guys showed up at our facility about
| 1 |
winsouce.jpg)