Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65
Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K
Electronics Forum | Wed Jul 14 12:03:53 EDT 1999 | greg c.
i have worked with the universal gsm in the past and am now helping out a contracting company who is setting up one in their facility. My question is: the power requirments for the machine calls for 3-phase 230V, does it really need 230V or is the s
Electronics Forum | Wed Jul 14 15:06:33 EDT 1999 | M Cox
| i have worked with the universal gsm in the past and am now helping out a contracting company who is setting up one in their facility. My question is: the power requirments for the machine calls for 3-phase 230V, does it really need 230V or is the
Electronics Forum | Thu Jul 15 15:37:04 EDT 1999 | David
| i have worked with the universal gsm in the past and am now helping out a contracting company who is setting up one in their facility. My question is: the power requirments for the machine calls for 3-phase 230V, does it really need 230V or is the
Electronics Forum | Tue Jan 07 07:55:24 EST 2020 | dekhead
If it happened after holiday shutdown; good chance you have onboard battery going bad (battery dropped too low during extended shutdown). Replace batteries to alleviate future occurrence.
Electronics Forum | Fri Mar 24 15:39:43 EDT 2023 | proceng1
We have a HELLER 1700 running at 208v on an 80A breaker. I doubt that helps much.
Electronics Forum | Fri Mar 24 15:08:20 EDT 2023 | erikfriesen
The nameplate specs for a 2004 Heller 1088EXL show 240V 60A, and specify Largest Heater Load of 25A. As each of the 8 heater elements is 6000W or 9.5R, how does this really work? Obviously all 8 elements on would pull 200A, so does the machine only
Electronics Forum | Tue Jan 27 21:46:53 EST 2015 | billnav
Does the DRS-24 rework station take single or three phase 208/240? Thanks in advance.
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
