Electronics Forum | Fri May 30 16:37:27 EDT 2008 | vms
With the price of gas at 4.00 or more, I'll take 2 of them mopeds! harry
Electronics Forum | Mon Feb 15 12:35:22 EST 1999 | Clifford Peaslee
On Saturday morning, 4:00am, the server that runs SMTnet had failed. Our technicians could not obtain replacement parts until this morning. We apologize for any inconveniences that this has caused, and we are currently taking measures to better ensu
Electronics Forum | Tue Jul 03 11:21:54 EDT 2007 | areed
I might be able to help. I�ve been manufacturing in the irrigation industry for around 20 years. If your retailing for $20.00 your cost should really be around $4.00. If you would like We could discuss p.c.b. layout, enclosures, packaging, & marketi
Electronics Forum | Wed Sep 12 13:11:50 EDT 2007 | nitro
Usually the bearings lock up. I keep one spare blower on hand and change it out when I have one go bad, then take the bad one apart and change the bearings. The bearings are about $4.00 per set and are pretty common. Not too hard to find. I am using
Electronics Forum | Fri Oct 04 01:18:27 EDT 2002 | sarge
1.5. Width >= 4-5 Particle Diameters. Use the smallest opening to determine this. Using dimension of the smallest aperture width, you should be able to fit minimum of 4-5 solder balls side by side into the opening. For 0201 design, -400 mesh (type
Electronics Forum | Mon Apr 09 14:53:19 EDT 2007 | flipit
Hi, We were running with few defects with lead solder paste. The lead solder paste with stencil 0.010" X 0.020" and 0.004" thick stencil produced near defect free PCB assys. 0.010" X 0.020" (0.004" thick) lead = defect free 0.010" X 0.020" (0.005"
Electronics Forum | Wed Sep 18 18:41:17 EDT 2002 | davef
People have made good comments. Additional points are: * Your bridging is probably being caused by one or more of the following: [1] printing too much paste, [2] smearing the paste during placement or subsequent handling, or [3] paste slump during t
Electronics Forum | Wed Aug 21 18:24:24 EDT 2002 | dragonslayr
surely, a big picture perspective is in order to keep from charging off, tilting at windmills and waning Quixotic. Just to tic ya off a bit more (come on now, smile), would those 2 boards in rework have just one defect each or are there multiple def
Electronics Forum | Fri Nov 01 18:57:32 EST 2002 | slthomas
I guess I just don't see how it would benefit us any. We rarely remove a board from the conveyor unless it's coming out of an oven. And why would you put bare boards on a tray? Why not into a destacker that feeds your line, so only the edges of a
Electronics Forum | Mon Sep 17 17:09:32 EDT 2001 | jschake
Flux: No-clean pastes tend to have a wider print process window in terms of print speed and pressure. More importantly, no-clean pastes are more tolerant to changes in temperature and humidity. They also exhibit longer stencil life than water-solub
.gif)
winsouce.jpg)