Electronics Forum | Mon Oct 26 12:56:23 EDT 2009 | rgduval
Eric, Protective sleeve? The sleeving protecting the wires of the thermocouples? I bought mine direct from Heller. I think it was $90 for a set of 3 (my oven uses 3 thermocouples). They are close to thirty feet long (I'm guessing...they're much
Electronics Forum | Wed Aug 30 21:44:56 EDT 2006 | IRAS
HI, I am looking for the smallest wave soldering machine available. So far I have found some that have a total of 8 feet in length, and a foot print of 5.5 feet wide. Is there a wave solder smaller than this?
Electronics Forum | Fri Apr 30 01:11:00 EDT 1999 | Dean
| We will be moving our entire plant in a couple of months . We are in the process of installing communication cable etc, to allow for a easy drop machine in line type move. ( is this possible) | My question is what type of communication cable would
Electronics Forum | Thu Mar 14 15:11:33 EDT 2013 | Andy
I am interested in performing SMT Assembly on flex boards that would be a couple of inches wide but 2 to 5 feet long. Obviously quite a challenge. I would like to hear from anyone that may have seen anything similar done, or at least has an idea of h
Electronics Forum | Fri Mar 02 03:14:01 EST 2018 | reckless
The budget is tiny, I agree. It is more to get our feet wet. We are mostly afraid of adding more steps in the process thereby making it more difficult to implement. I want to avoid a wave soldering machine and also want to avoid making two passes
Electronics Forum | Wed Mar 20 11:47:06 EST 2002 | Hussman
Ron, Some places want/need oven calibration and some don't, just need a profile. I've worked for both. If you need oven calibration, an easy, inexpensive way is to parallel thermalcouple wire to your existing thermalcouples. Terminate the ends of
Electronics Forum | Mon Nov 25 22:08:05 EST 2002 | Ben
Thanks for the advise. I got the advise from my solder paste vendor to increase the time above melting point for flux outglassing to escape. I tried but no big help. For the moisture issue, actually I've try to bake both the PCB and components at 12
Electronics Forum | Wed Dec 08 20:47:01 EST 2021 | cbeneat
It's funny, we expanded with 2 additional lines a few years back. Set them up for exactly what you're saying, the end of one is 5 feet from the beginning of another. Operator would only have to pull the magazine from the mag loader, turn around and l
Electronics Forum | Wed Mar 07 15:38:53 EST 2007 | Michael Konrad
I know Los Angeles was not a favorite destination for many visitors but some facts remain clear: APEX Southern California featured 446 exhibitors in 161,400 square feet of exhibition hall. APEX Southern California had a total of 5,087 verified at
Electronics Forum | Wed Mar 08 19:29:55 EST 2000 | Charles Leech
This is just an Alert: We had a lesson on the effect of air shipments of devices which have been fully saturated with moisture. After being in a pressure cooker for two hours in Singapore, devices were sealed in metalized vapor barrier bags. They we
winsouce.jpg)