Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Wed Feb 23 15:07:58 EST 2005 | bobpan
Hello C.B. I am a former trainer/fse for that machine and still have a q1000 bible for fixing problems. I think the machine may need servo tuned to which there is a procedure that i would have to find. First thing to do though, is to drop the machine
Electronics Forum | Mon Dec 06 21:07:36 EST 2021 | victorzubashev
Hi, you have flickering that affects all AC power in the machine (PC is also connected to the AC line (after step down transformer)), correct? Do you intermittently/randomly lose power in all machines units(MC/PS/Servo)? If I understood you correctly
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Wed Oct 12 17:45:07 EDT 2022 | rmcmartin
I received an error message from our Sony F209 pick and place machine saying E17 servo controller is in emergency stop. It says the remedy is to cancel the input or replace the cable. where is the E17 servo controller and how do you cancel the inpu
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Wed Mar 07 14:55:13 EST 2018 | cyber_wolf
In my experience that error almost always indicates a bad amplifier.
