Electronics Forum | Tue Feb 03 02:55:04 EST 2015 | max83
Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration.
Electronics Forum | Tue Feb 03 02:41:17 EST 2015 | vitrost
Hi, We have a snap-off issue. I guess it can be linked to z calibration.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
Electronics Forum | Mon Dec 20 04:41:38 EST 2010 | accuspares
Hi, The input indicators can be located by selecting the 'Input' page located in the 'Diagnostics' drop down menu. Just select the Align tab at the top of the page and you'll be able to see when the nearly home and home sensors change state. The pr
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Sat Dec 04 12:47:36 EST 1999 | Robert Halliday
Run a DTI over the X and Y edges of the table to ensure that your XY table is flat, adjust the four small screws to suit. Also check that the Z cams are not worn and that the Z cam followers are not siezed or worn(they are prone to flat spots when wo
Electronics Forum | Mon Jun 19 15:13:42 EDT 2006 | Chunks
There is also plastic link on the shaft that raises your Z-Table that may have come lose or broken. Is the Z-Table able to move up and down in Supervisor mode?
Electronics Forum | Thu Jan 29 10:05:28 EST 2009 | soudomphong
I am looking for rolling table z-axis p/n 00320165-02. for rv-d head siemens S20. Anyone know where to get it or have it, please contact me via email seth.oudomphong@variosystems.com Thank you. Seth
