Electronics Forum | Thu Nov 01 01:48:14 EST 2001 | hamos_wks
168hrs, 1week of storage and frequently applied for rework after testing.
Electronics Forum | Fri Nov 22 10:38:30 EST 2002 | slthomas
The follwing is from the Technet archives, per IPC's Jack Crawford. I dug it up during some investigation of a supplier's issues with humidity in an Asian plant: There is support for this in IPD-HDBK-001 w/Amendment 1 Handbook and Guide to Suppleme
Electronics Forum | Fri Nov 02 12:01:26 EST 2001 | mparker
I have two cases where I must bake after DI wash. The moisture entrapment is specifically within microprocessor sockets. Without air gun blow out and baking, oxidation occurs that causes flaky contacts for the PGA. We will bake for 2-3 hours @ 60C. O
Electronics Forum | Thu Nov 01 00:32:14 EST 2001 | ianchan
we bake boards 80~120 deg-C @1hr, after in-line DI wash. oven setting to 90 deg-C, as +/-5 deg-C, tolerance against door open/shut fluctuations = "temperature loss". If anyone has evidenced procedure, that shows no need for baking, pray do share wi
Electronics Forum | Tue Oct 30 21:42:32 EST 2001 | surachai
I have question about board baking after in line washing machine then I would like to know some information that ; 1) Do we need board baking after in line washing machine? Both bare board and assembly borad normally we don't bake . 2)In case of ne
Electronics Forum | Thu Nov 01 17:36:20 EST 2001 | davef
We don�t bake between routine washing between soldering cycles. We bake when we immediately go to test or box-build. Certainly, it all depends on your process, materials, and boards. So, how did you determine that you needed to spend the money? I
Electronics Forum | Tue Jun 17 09:00:58 EDT 2003 | fmonette
Good question, here is the short answer : The problem is that dry storage is not the same as a bake process. If you want to bake saturated components, this should be done at higher temperatures. The IPC/JEDEC standard provides a table with bake temp
Electronics Forum | Thu Jul 12 02:15:53 EDT 2012 | thmeier
Check also the specs / recommendations of your PCB manufacturer. We bake boards 4h/120°C before reflow and after automated cleaning (it´s not FR4!) and also if we have to rework with the autometd rework- stations (massive IR underheating ,..). Regar
Electronics Forum | Wed Jul 11 22:48:54 EDT 2012 | joeion
It is correct to remove moisture in PCB by baking. But I think the time and temperature is too little. According to our experience, it should be more than 60min at 120 centigrade degrees.
Electronics Forum | Thu Jul 05 21:07:09 EDT 2012 | davef
Probably they had a problem with a certain product, tried baking, the problem went away and ever since there stuck with this money loosing process. So, ... * Write up a plan to split a couple of batches, bake a portion of each batch, don't bake the o
.gif)
.gif)
