Electronics Forum | Wed Apr 01 19:04:56 EDT 2020 | tima
Does any one have Air Vac Onyx32 with DL Dispenser? I need to get a screen shot with motor setting (will guide you where to get this). Can pay for screenshot. Can not find anywhere... Please help
Electronics Forum | Mon Jul 23 08:52:20 EDT 2018 | mgerrior
Hey Everyone, looking to purchase a new rework station to support large PCBs. Currently up to a maximum of ~ 21" x 18". Does anyone have experience with any of the following equipment or can recommend from other manufacturers? - VJ: Summit 2200
Electronics Forum | Fri Aug 06 13:41:29 EDT 2004 | mdang
I am looking to buy an used Air-Vac DRS 24. Does anyone has experience with it? What do I need to look for and what different between the 24 and 24C? Thanks for your help. -Michael
Electronics Forum | Fri Jan 27 12:42:51 EST 2006 | rohman23
We're looking into ways to better protect components adjacent to reworked ones with our Air-Vac. I've seen a few recommendations involving aluminum tape and other masking materials, but am looking for better recommendations. I noticed Alpha Metals
Electronics Forum | Tue Aug 22 03:04:07 EDT 2006 | PP
Any help/suggestion is much appreciated I am doing lots of BGA Reworks from a small uBGA with a few balls to a large BGA with over 1500 balls. The reworks have been done on SRT 1100 Series Machine for many years. SRT 1100 Machine is good for the c
Electronics Forum | Tue Sep 28 07:46:30 EDT 1999 | g cronin
if anyone has used or has one of these bga rework stations please give me your opinion on them. I am planning on using the sytem for not only rework but also low volume prototype production for hand built 1 or 2 qty pcb's, so ease of use is importa
Electronics Forum | Fri Aug 10 13:30:46 EDT 2001 | mzaboogie
Good Afternoon. Hope all is well with everyone. > I was wondering, What is the preferred equipment > to use for BGA rework/replacement and xray? I > would like to know what equipment you are using > and your likes/dislikes of the equipment.
Electronics Forum | Sun Jan 10 19:51:20 EST 1999 | Chris G.
| I need leads on equipment vendors for selective soldering systems. I have information about ERSA and Seho already. I want to contact Air Vac in particular, but I can't find thier phone number. Thanks for the help | Jim, Below are a couple of
Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Fri Apr 20 18:21:55 EDT 2007 | Hegemon
Consider how the vast majority of PCBs with BGAs are produced. Forced air convection. Anything that comes closer to duplication of the original soldering profile is what you desire. Did they build it with IR or Convection? The process engineer wa
