Electronics Forum | Thu Nov 01 02:45:47 EDT 2007 | laplooi
Whe have the Mirtec about 2 years now, the question is, that when you have 100 components to check he give's 20 to 30 failures that no failures are. are there people they have the same problem?
Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Fri Apr 02 04:02:18 EDT 2010 | manju2cool
Hi, I think concept of inspection through AOI is changing. I am struck in confusion.Because some manufacturer say 3D inspection, with 1+4 cameras is ultimate solution. Orbotech also came with 13 cameras at once!Now some say, all these are eyewashing
Electronics Forum | Fri Apr 02 10:26:13 EDT 2010 | fishingfool
Manjunath The top camera will be used for probably 90-95% of your inspection needs. However, without side cameras that 5-10% of uninspected parts can be a real pain to manually verify. What you need to figure out is what is your product to inspe
Electronics Forum | Tue Mar 30 05:03:56 EDT 2010 | markslade
Thanks for your help. mark.
Electronics Forum | Tue Mar 16 11:39:13 EDT 2010 | markslade
I have a mirtec MV-3L, does any one know, when drawing a component part with varios side angle camera views can i group that part and its camera views to save in the library and if so how?
Electronics Forum | Mon Mar 29 10:20:29 EDT 2010 | CL
Good Morning Mark, I do not believe that you can group images from multiple cameras. You can save a camera image into the library but you would need to re-name the part number for the side camera if you have an image from the downward looking camera
Electronics Forum | Wed Oct 22 01:14:04 EDT 2008 | maheshbs
Conveyor is installed after AOI machine. After inspecting the board in AOI it sends the signal to the conveyor whether it is Good board or Bad board.
