Electronics Forum | Mon Sep 23 12:44:48 EDT 2002 | daanterstegge
Another issue to look at is the efforts that it takes to become familiar with the machine. Where I work we are also looking into AOI machines, and one of our requirements (based on how simple the vendors say their machines are) is that after no more
Electronics Forum | Fri Sep 20 14:23:50 EDT 2002 | larryk
PizzaFred, Scott mentioned lots of good ideas. Take one of your boards to each vendor and see what it takes to program the board how long it takes for it to become online. I've found some that are easy to program, but require 40 or more assemblies to
Electronics Forum | Mon Sep 23 13:08:47 EDT 2002 | dragonslayr
Daan has made a valid point with regards to expertise and use of a machine. Yet I recognize that with advanced technology, trades must occur. A hghly sophisticated AOI unit can and will help reduce overall cost of production. Therefore, a need to ha
Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Wed Aug 22 12:30:34 EDT 2001 | slthomas
Now that's an approach I've never thought of, inspecting a different portion of each board (I'm assuming that you program a few different patterns and run them sequencially, or something like that). I know our stencil printers don't provide that opti
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Sat Jul 16 07:07:42 EDT 2005 | dd
Hello. I would to get any recommendations about saving techniques of aoi templates. Here some options iv thought for: By the number/name of the component By the component type (plcc,bga...) By the GF we get from the camcad files (102,103....) Any oth
winsouce.jpg)
