Electronics Forum | Thu Oct 15 05:00:23 EDT 2009 | taus
Hello, Thanks for the comments! The problem is solved, I was browsing this forum and found a topic referring to AP.CAL. Than I realized that the person that worked with the machine before me, altered this file. The values were all altered but he k
Electronics Forum | Tue Jul 27 19:37:51 EDT 2004 | simmcircuits
Thank you Paul, this is the actual information I need to adjust the camera! At the moment I have actually reduced the offset values down to 0.7 from a previous 4.0. I have done this by editing the AP.CAL, took a while to get the proper values as I ha
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Tue Jul 27 19:02:46 EDT 2004 | pdeuel
Not an easy task and requires calibration jig. MPM support field service is your best bet. The adjustment screws for the prizm located on left side of camera will adjust the x direction. There is a set screw on the front that must be loosened first.
Electronics Forum | Fri Sep 22 12:21:06 EDT 2006 | daxman
We are using the Universal tooling..the one with the side plates. I'm not sure what the C-tool is. The machine did not come with much. I'm running the vision system test now..I've never done it before..but I'll let you know what happens with it. To
Electronics Forum | Tue Sep 26 09:57:19 EDT 2006 | daxman
Thanks Chris... I do not have the c-tool, but I did make some adjustments to the middle cube when I was calibrating it. Like I said in an earlier post, I cleared the vision offsets in the ap.cal file and adjusted the middle cube until the board alig
Electronics Forum | Mon Oct 02 09:24:48 EDT 2006 | Chris G.
Daxman, Did you get my e-mail? I'm feeling generous today, so I can fax you cal. proceedures and maybe loan you a c-tool. Let me know if you still need help.
Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.
Electronics Forum | Mon Feb 18 10:06:00 EST 2002 | caldon
TECH 127- I have some data points I could share with you on APS but being a competitor I do not want to clog the SMTNET Forum with "non-technical" information. My email is Cdriscoll@manncorp.com , please send me a list of questions or issues and I c
Electronics Forum | Fri Sep 22 09:06:33 EDT 2006 | daxman
We've got a problem with our AP25.. I just finished repairing and calibrating this printer. We needed to replace the camera. After the cal. was done, the print accuracy was superb. However, it seems now, the consistency will not maintain itself. T
