Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Mon May 02 23:42:44 EDT 2016 | ttheis
I have a strange issue where all 4 spindles of head 1 on my GSM1 are able to place small parts without a problem until the very end of the routine where a large electrolytic aluminum capacitor is placed. The part is successfully picked out of the fee
Electronics Forum | Tue May 03 19:52:09 EDT 2016 | ttheis
OK, I forgot to import the new order into the task block builder but that didn't resolve the issue. I decided to reduce the height of the part in the definition from 510 mils (which it is) to 450 mils and it places without a problem. Its strange bec
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Wed Jul 12 16:39:59 EDT 2006 | SWAG
Can anyone help point me in the right direction on fixing problems related to the following Universal GSM2 errors?: 1) Axis head 1 Z position following error during Move Absolute command. 2) Axis head 1 Z error not recognized during Move Absolute
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222
I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an
Electronics Forum | Thu Mar 04 22:52:57 EST 2004 | Roberto Rodriguez
i have a Universal GSM2 machine down and we check all, but are exaust, the problem is the next, when we make Zero axis tha machine say "AXIS HEAD1 Z POSITION ERROR DURING MOVE RELATIVE COMMAND" AND "TIME UP SPINDLES UP". DO YOU HAVE EXPERIENCIES AT T
| 1 |
