Electronics Forum | Wed May 17 17:13:47 EDT 2000 | Michael Parker
The MoonMan has spoken. Everybody get back up on the wall, its been long enough that this has been "off the wall". Wish I had more Rambus chips, just got my SMT process dialed in and ran out of stock. Damn.
Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Mon Jun 15 19:51:48 EDT 1998 | Earl Moon
I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. Deeply invloved in micro BGA, CBGA,
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Thu Nov 07 21:28:31 EST 2019 | sssamw
The connector is so long, and has big metal parts, it will be little deformed during reflow I guess, andthe pins planarity should be critical for 200 pins. Did you measure the non wetting pins profile to see if temperature ok? And maybe you can try u
Electronics Forum | Tue Apr 19 10:19:28 EDT 2011 | leemeyer
We currently have a job that uses press fit solderless pins. The pins are custom and only supplied in bulk packaging. I am looking for a machine that can orient the pins and present them to my insertion machine. Of course i need the pin to be present
Electronics Forum | Fri Feb 22 13:19:54 EST 2013 | caurbach
Our new Soltec Delta 3 has this feature (they call it mainwave pushup) where you can add up to 60 rpm to the pump after the leading edge passes over the wave. Unfortunately, our old Delta Wave doesn't have this feature. Ideally we'd like to set it
Electronics Forum | Tue Jun 16 15:39:43 EDT 1998 | Steve Gregory
| | I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | | Deeply invloved in micro BG
Electronics Forum | Tue Jun 16 14:10:11 EDT 1998 | Wayne
| I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | Deeply invloved in micro BGA, C
Electronics Forum | Tue Jun 16 09:03:57 EDT 1998 | Justin Medernach
| I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | Deeply invloved in micro BGA, C
