Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
Electronics Forum | Tue Apr 04 02:46:39 EDT 2000 | George Verboven
We are looking for a way to cure conductive adhesive. I heard about curing times from 2 hours and more. But I also received information that curing can be done in 10 minutes at 120 C. Of course it also depends from the type of glue. But the question
Electronics Forum | Thu Apr 19 01:50:49 EDT 2018 | leeg
Whats the best way to joint a broken conveyor drive belt? Ive tried a rubber glue which lasts for a short time and tried touching both sides to an iron tip and then holding together, again with poor results.
Electronics Forum | Mon Aug 21 11:15:31 EDT 2006 | aj
All, We have a conveyor that uses an o-ring belt , this belt breaks quite regular which causes a hassle for the SMD Ops. The stuff we use is from Radionics,its 3mm also. Anybody recommend a good belt or procedure for joining them together( we curr
Electronics Forum | Wed Feb 07 16:16:10 EST 2007 | mr
I have seen this before. Check: --Vibration of belt --Interference (part getting "brushed off" while reflowing bottom-side components --Some glues' cross-linking mechanism is impaired by the flux during migration in reflow, redering the glue useless
Electronics Forum | Sat Aug 18 23:03:07 EDT 2012 | eadthem
We have had this problem in the past, On paper tape resistors(old stock from before i took over and forced rotation on everything) and on embossed (national semi parts, strings of glue pulled back like seat belts across the pocket.) For the national
Electronics Forum | Fri Jun 15 01:23:45 EDT 2007 | darby
Sami, What happens at the oven? Running on belt mesh with several pcbs side by side?
Electronics Forum | Sun Jun 17 08:40:37 EDT 2007 | sami
Yes We have a belt mesh oven with several PCBs side by side . but the problem I am talking about is before the oven because if we have more PCBs inserted the oven can order them with any problem ( SMEMA ) . bets regards
Electronics Forum | Wed Jan 20 04:21:11 EST 2010 | josh_brubaker
If it's just a break, you can easily glue it with a 2-part glue from Coolchem.com Look for the Integrator 75 and Activator 310. I was surprised at how well the glue holds up. This is one of those mystery products where the repair becomes stronger th
Electronics Forum | Wed Apr 08 05:41:37 EDT 1998 | Alan Pestell
We currently use the Loctite system of Glue/stencils and are getting very good results. You may still have a height problem is you solder resist is too thick. The UK sales person is Bob.goss@loctite-europe.com & he may give you more help. The only ot
