Electronics Forum | Wed Apr 16 20:22:13 EDT 2003 | praveen
Hi, I have taken the profile.The peak temp. at the lead terminal is 219 degc, duration above MP 54 sec and duration 125 deg C-160 deg C is 60 sec.
Electronics Forum | Thu Apr 17 10:25:42 EDT 2003 | davef
You'd think 219*C should be warm enough, but we'd go higher just to get the part to stick. What is: * LED terminations material? * Alloy and flux type of your solder paste? Is you solder sticking to the pad and not to the component? Or what?
Electronics Forum | Wed Apr 16 01:40:17 EDT 2003 | praveen
Hi , We are using water wash solder paste to solder the SMT LED's manufactured by Chicago Miniature lamp (CMD93-21 & 22)and Kingbright. Achieving the solder fillet , wetting has no issue but we observe high fallout at the functional testing. If we do
Electronics Forum | Wed Apr 16 08:43:00 EDT 2003 | davef
Given that the LED work properly after being touched-up and that you don't have problems with other components, you may not be wetting the LED termination solderability protection during your normal reflow. Use a profiler to check the temperature on
Electronics Forum | Wed Sep 30 08:21:07 EDT 2009 | cunningham
Hi We have a board at the moment thats passing ICT and passing functional test but its failing test after conformal coating has anyone had any experinces of this? or any idea what may be causing this?
Electronics Forum | Thu Jan 08 10:56:13 EST 2009 | aj
Hi, Is there any PTH Assembly after reflow, we found cracked joints on some BGAs which was caused by operators ing Oupin connectors which were a tight fit. This caused the PCB to flex hence cracking joints. One way of checking for this during test
Electronics Forum | Fri Jan 16 14:42:44 EST 2009 | realchunks
Kester R562 is a 63/37 paste. Not ideal for no-lead parts. I bet you are seeing no-lead BGAs and they will become very weak using your old proile and paste (been there - done that). You can try a hotter profile but will probably just burn off your
Electronics Forum | Mon Jan 12 02:29:13 EST 2009 | sachu_70
Hi Milan, One cause for such BGA failures could either be a laminate warp (bow or twist) formed during your Reflow or Wave soldering process, or perhaps a warp seen on the BGA component package itself prior to processing on SMT line. IPC guidelines f
Electronics Forum | Wed Jan 07 00:18:14 EST 2009 | milanrit
Recently on one of my assemblies(sn/pb) I started seeing leaded BGA failure at functinal test for opens, but when I inspected them through 5DX and ERSA Scope it doesnt seem like there is any opens or insufficient and half no. of boards passed functio
Electronics Forum | Mon Mar 21 02:41:29 EDT 2011 | kemasta
Hi It's me again. Our products need to pass a chamber test 45c/36hrs after the PCBA completed batch of functional tests and assemble in to case. We found 1 unit was functioning for 24hours in the chamber, but hang after that. We tried to re-boot the
