Electronics Forum | Thu Apr 08 16:25:38 EDT 1999 | greg c
I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling thank you
Electronics Forum | Fri Apr 09 12:46:10 EDT 1999 | Bob Barr
I have been using an Air-Vac DRS-22 for almost two years with very good results. Once a profile is developed it is very repeatable. The DRS-22 is no longer available, however. It has been replaced by the DRS-24. Unfortunately, the DRS-24 has a lo
Electronics Forum | Thu Apr 08 21:23:21 EDT 1999 | Dean
| I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling | | thank you | -I have had wonderful results with SRT. Che
Electronics Forum | Tue Apr 13 18:12:54 EDT 1999 | David
| I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling | | thank you | You might want to look at Advanced Techniques
Electronics Forum | Sat Apr 10 10:01:43 EDT 1999 | Jeff Price
| | I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling | | | | thank you | | | -I have had wonderful results with
Electronics Forum | Tue Feb 05 20:31:39 EST 2013 | hegemon
Air Vac DRS25. Hands down the best rework EQ. (my humble opinion, based on my own experience with rework EQ going back 15 years +) Right in your budget. Complete capability for rework. SMD, BGA, POP. Full profiling capability. Massive bottom heati
Electronics Forum | Wed Jul 22 13:57:03 EDT 1998 | bill
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai If you are doing any reballing
Electronics Forum | Tue Aug 25 08:14:55 EDT 2009 | davef
Among the best BGA rework systems are: * SRT http://www.vjelectronix.com/vjebeta/products.asp?title=Rework%20Solutions * AirVac http://www.air-vac-eng.com * Metcal http://www.metcal.com * ERSA http://www.ersa.de/en
Electronics Forum | Sat Jun 05 13:38:22 EDT 2021 | ppcbs
For Linear Tech LGA's we solder bump the LGA using a .30mm solder ball then reflow with a tacky flux. This will provide a void free solder joint and adds a little height to the solder joint in case you use a flux that you want to clean from under th
Electronics Forum | Tue May 11 12:02:03 EDT 1999 | Tony
| We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | All other tips are also welcome. | | Thanks | Philip, I have been doing BGA rework for
winsouce.jpg)