Electronics Forum | Fri Jun 09 20:13:36 EDT 2006 | grantp
Hi, We have spent the day trying to profile our Vitroncis Soltec Delta C wave with the new SN100C solder, but having problems with the heavy pins on some BNC connectors we are using. We have Interflux no residue flux, and we are using palettes, whi
Electronics Forum | Mon Apr 21 12:46:48 EDT 2003 | jonfox
It sounds as if the boards are designed in-house. Is this correct? If so, look for SMT versions of the BNC connector. I hhave used one from Johnson Components (http://www.johnsoncomponents.com) or look through http://coaxicom.com for something yo
Electronics Forum | Mon Jun 12 14:16:23 EDT 2006 | Kip the Expert at all Things SMT
Hi. I agree that the Soltec has weak, low-wattage preheaters, and also, the Soltec's fluxer is flippin' weak too. It doesn't do a good jab of atomizing the flux and getting good, huh-huh, penetration on the holes. I cranked up my Soltec's pressu
Electronics Forum | Wed Apr 23 19:24:29 EDT 2003 | MA/NY DDave
Hi Grant, You already have a few good answers. If you have but one to a few BNC connectors I would kind of use the advice here or do what you already are doing aka hand soldering. I would not install a Wave Solder line for a really low volume of BN
Electronics Forum | Thu Aug 07 18:28:28 EDT 2003 | Dean
Is it possible the solder hole(s) is too large and the solder is falling back in the hole? I see this on right angle BNC type connectors. Is this happening on all component types? All areas of the boards? Always the same pins (but other pins in t
Electronics Forum | Mon Apr 05 08:21:14 EDT 2004 | Grant Petty
Hi, Thanks for the tip, and I will check that out! We have some heavy BNC type connectors, so they need a bit of heat, and this could be right that we are then overheating the flux. Regards, Grant Blackmagic Design
Electronics Forum | Thu Jun 08 19:51:22 EDT 2006 | grantp
Hi, That's good news, and we did outs with SN100C as well on Wed, however we are still working hard on getting a good profile. We have some large BNC connectors, and they are hard to profile. We also have wave palettes, and these might be too thick
Electronics Forum | Mon Feb 09 14:31:38 EST 2004 | Brent
There is standard pick and place equipment such as the Assembl�on (formerly Philips EMT) ACM Micro and AQ-1 that can easily handle your snap-fit through-hole BNC connectors, in addition to other surface mount components and through-hole odd form part
Electronics Forum | Mon Apr 21 06:26:28 EDT 2003 | Grant
Hi, We have a SMT production like, however we have very little experience with through hole assembly. We design everything to be completly SMT based, however connectors are the only part of our product that still requires through hole assembly. Cur
Electronics Forum | Mon Jun 12 09:47:18 EDT 2006 | patrickbruneel
Hi Grant, You definitely have a pre-heat problem and not a flux problem. Pallets together with the BNC connectors put a large thermal demand on your pre-heating. 3 zones would be a good investment even with leaded solder due to the high thermal dema