Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Thu Apr 04 18:38:08 EDT 2024 | ronh22
I have the rear panel off and I can see the Drive but there is very little clearance looking down or working. Where are the fuses located? We also had the breaker pop a few times on out main breaker before this happened.
Electronics Forum | Mon Sep 28 14:02:15 EDT 2009 | swag
As mentioned previous, check all fuses & breakers. In the AC chassis (should be under black cover beind front, right door), remove cover and check main circuit breaker. Also should be two fuse housings next to breaker - if they are lit up amber, th
Electronics Forum | Mon Jun 13 17:51:24 EDT 2005 | peter ng
Check the thermal heater,the cooling fan,the contactor breaker,it is faulty?
Electronics Forum | Tue May 07 11:19:54 EDT 2013 | bobpan
Have you checked to make sure the front or back E-stop is not pushed in?
Electronics Forum | Fri Aug 24 00:01:23 EDT 2018 | leeg
Have you tried to re-load the MINT software 1st? Are the breakers in at the back of the machine?
Electronics Forum | Tue May 07 13:32:15 EDT 2013 | bobpan
Sounds like you may have a z-axis problem. I would check the axis out and run the z rod up and down by hand to see if there is a problem....sticking,sensor/flag broken....etc. Maybe you can unplug the z-axis card and then turn the machine on to see i
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Sat Feb 20 20:45:53 EST 2010 | dekhead
Sounds like you have a Switched 12V issue. Breaker on rear of Machine. Fuse in Y1 enclosure. PSU3 (on floor of) Y4 enclosure.
winsouce.jpg)