Electronics Forum | Tue Jun 04 11:17:39 EDT 2019 | dman97
Does anyone have a manual for a BTU PYRAMAX 150N X5 oven? We recently got one of these used and it has the flux management system attached along with a water chiller. We hooked everything up, but the oven throws a water supply problem alarm. Chill
Electronics Forum | Tue Nov 30 14:29:52 EST 1999 | Jay Claybrook
Looking for information on portable chillers or coolers used with the water type recirculation heat exchanger cooling modules on the TRS21 BTU double furnace ovens. For use where you don't have a chilled water supply in the facility. Any info would
Electronics Forum | Fri Jun 17 00:19:59 EDT 2005 | ajaydoshi
Hi just reading your problem with your BTU oven. > We have a similar problem with our oven, did you > find a fix for it. Not solve yet in a conclusive manner. But problem likly from fan speed & water supply. thanks Ajay
Electronics Forum | Thu Nov 30 10:38:39 EST 2006 | billwestiet
You are cooling too fast, and some flux and paste is worse than others... Can you control your cooling zones? Water Temp (higher)? Or Water Flow (less, effectively less cooling)? Changing water temp is prefferable over flow if you can do it. I h
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Tue Aug 22 15:22:46 EDT 2023 | thecolonel97
Our paste manufacturer failed to respond. I did try adding 2 frozen jugs of water into the reservoir tank, this did not lower the cooler 1 temp. We have to have a water or air flow restriction causing this to run hotter. Still currently investigat
Electronics Forum | Tue Oct 18 17:06:04 EDT 2005 | stepheniii
At one time I could show you the spacing of the chain of an electrovert but the burn marks have dissapeared. The center support chain would wrap around and jam up and with boards in the oven.............. On that one for some reason we bought it wit
Electronics Forum | Sat Dec 30 00:02:10 EST 2006 | Mats
Hi, A couple of another things is to check: * The cooling water supply (assuming that your oven has this feature). * The fans (Just open the hood and check if every fan, up & down is running). * Open the back panels: and you should see some "black"
Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
Electronics Forum | Wed Aug 09 12:11:44 EDT 2023 | thecolonel97
We are currently experiencing an issue with one of our reflow ovens producing large amounts of flux crystals in the end of zone 12 and entrance of cooling zone. This has been going on for roughly around 4 years now, we are using Senju M705 lead free
