Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
Electronics Forum | Wed Aug 09 14:36:30 EDT 2006 | cyber_wolf
Swag, I think I have mentioned this on the forums before....The only way to truly get those chains clean is to use a foaming oven cleaner. It requires several applications to get them completely clean. Also, you need to remove the tracks and clean t
Electronics Forum | Wed Dec 11 12:43:03 EST 2002 | kerryn
We use our ultrasonic stencil cleaner. Before we change the wash solution, we clean pallets, chains, fingers, etc. It does a good job and takes only a few minutes.
Electronics Forum | Wed Dec 18 15:00:17 EST 2002 | Chris Lampron
Good Day, We have been searching for ways to do this very thing. We have sent them out for cleaning in hot baths, ultrasonics, pressure wash, etc... The chains have come back cleaner than they left but not perfect. At one point, one of our engineers
Electronics Forum | Fri Jul 28 11:16:09 EDT 2017 | robertwillis
Yes it happens with any inline cleaner with small or light boards the pressure can cause them to flip. If they lodge in the links they can also cause damage to the conveyor. For small boards, flexibles etc you do need a mesh fixture of some sort or l
Electronics Forum | Thu Mar 29 14:01:26 EST 2001 | Mike Konrad
Hi Bill, spin doctor Function: noun : a person (as a political aide) responsible for ensuring that others interpret an event from a particular point of view You made your point and I made mine. I will apologize to the readers for the excessive ban
Electronics Forum | Thu Jul 25 12:25:54 EDT 2019 | davef
In “J-STD-001 Rev G Amendment 1 Process Qualification” Debbie Carboni, Global Product Line Manager, KYZEN Corp, Nashville, TN said: What change constitutes a need for requalification? Major/ Level 1 – Flux or flux-bearing materials (e.g. flux, so
Electronics Forum | Thu Sep 06 10:34:21 EDT 2001 | Mike Konrad
Hi Jeff, Sean is correct. Although ultrasonic technology will work in post-reflow de-fluxing applications, you will receive concerns regarding ultrasonic �damage� to wire bonded components. Much has been written to combat this belief but the conce
Electronics Forum | Tue Apr 14 15:42:45 EDT 1998 | Scott Cook
| Scott, | I am not really in a position to answer this as fully as I would like because most military work with which I am familiar is subject to some degree of secrecy most especially on the internet. At least we have signed up to such restrictions