Electronics Forum | Tue Sep 13 18:32:20 EDT 2011 | marcelll
I have all the kits & jigs to service GSM I'm doing it for 20 years at much better price then Universal Contact me if interrested Marcel Duclos info@controlemd.com
Electronics Forum | Thu Sep 08 18:01:22 EDT 2011 | comatose
We had a camera die on one of our GSMs. I got a new camera, and it is working, but I need to either find a cal kit to rent for a day, or else if someone knows a reasonably accurate procedure to calibrate the new camera using the other upward looking
Electronics Forum | Wed Sep 21 15:13:08 EDT 2011 | gregcr
Where are you located? Along the same lines, I have a trick I used a couple times when replacing a camera. It is often not the image sensor that goes bad, but the camera electronics behind the sensor. I have had luck taking the camera apart but le
Electronics Forum | Tue May 17 06:05:13 EDT 2011 | bobpan
The camera's are different. I think you can get them repaired but you should be able to find used/new ones. Try PPM as a supplier of old quad parts. Good luck
Electronics Forum | Tue May 17 16:18:42 EDT 2011 | danaherr
Thank you. I contacted them today. Their tech thinks it's the camera module box, so we're going to order one from them. Thank you again for your feedback. Dana H. Jade Protronix Arlington,WA
Electronics Forum | Mon May 16 22:06:22 EDT 2011 | danaherr
Downward looking camera not working. swapped cables on board and upward looking camera works when plugged into downward camera's connection on video card. Thinking maybe a cable issue??? manually moved gantry all over trying to see if intermitent ope
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos
Electronics Forum | Mon May 16 06:02:14 EDT 2011 | bobpan
Multiple times i have seen where the downward camera lens inside of the camera becomes detached inside. It is just glued down. To see if this is the problem. Park the head over a spot and tap on the camera every direction. The crosshairs should NOT m
Electronics Forum | Wed Mar 02 11:09:10 EST 2011 | cyber_wolf
I highly doubt they will even sell you the camera without setting up a service call.
Electronics Forum | Sun Sep 25 16:45:38 EDT 2011 | cbroegger
Have seen this with bad/intermittent connections to the camera. Replacing the cable fixed this.