Electronics Forum | Tue May 25 10:11:42 EDT 2021 | starsanat
Hello to you all. we got a CP45FV-NEO machine. it shows image1 error and I have no idea what this is for. please help me through it
Electronics Forum | Sat Jun 05 22:07:50 EDT 2021 | danniedarko
Hi, I live same error 3 years ago. I can fix this problem. but need remote access by (AnyDesk) software. and have 50USDT cost. send access information dannie.darko@outlook.com
Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
Electronics Forum | Wed May 26 04:51:12 EDT 2021 | starsanat
Thank you for your attention. It shows an error on startup too, so it get closed by itself. when I start it manually it shows the above mentioned errors. So I should never open up Mark3 manually right? I'll clean everything up and tell you the result
Electronics Forum | Wed May 26 06:07:07 EDT 2021 | bukas
its not that you should never open it manually, it just can be a problem sometimes. CP45 have a few problems with data corruption and this can be one of them. just make sure you regularly backup disk, and dont delete old backups straight away.
Electronics Forum | Fri Feb 01 19:07:57 EST 2002 | fujiguy
Yes Smema is used in the industry. It allows the equipment of different manufacturers to comunicate with out extensive rewiring. Both SMEMA 1.0 and 1.2 are used. An experienced SMT manufacturer wil include both for options.
Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Tue Feb 21 18:40:14 EST 2006 | Mike
I have RH machines (18 machines RH,RH2 RHU and RH3), for comunication we are using PanaPro, need to buy it from Panasonic and pay licenses.Also they can give the manuals.
Electronics Forum | Tue Jun 07 02:44:45 EDT 2011 | fholtman
The hardrive on our oven just crashed so we swapped computers with a backup we had made for it, however now we are getting a comunication with controller alarm...... any ideas would be much appriciated
Electronics Forum | Tue Aug 17 01:03:21 EDT 2010 | dan_ems
Hello, If you have a conveyor at the output of the pick and place machine with SMEMA comunication between CP20 and the conveyor you must have check it SMEMA in setup (Sys Setup / Preferences)like in the picture. If you dont have this type of convey
.gif)
