Electronics Forum | Fri Jan 18 08:38:54 EST 2019 | kgarlapa
We use gerber file for pick and place in smt machines, but in aoi we use cad files. Can you please suggest me how to convert gerber file into cad file by using cadEasy software of omron.
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Fri Nov 22 14:35:56 EST 2024 | carl_p
Depends on your software level or age. There is a software option to just change this on the newer stuff. Do you have any older cyber optics kit - you can use the older cal kits for other cyber machines - if you have them of course.
Electronics Forum | Tue Jan 16 07:51:23 EST 2007 | leemeyer
I have found a screen in the software that appears to be some setup data for the conveyor. I cannot find any information in the manual refering to this screen. If you open "SCREENS" then "DEBUG DATA" then "CONVEYOR" there are some setup parameters. D
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Fri Feb 23 15:22:42 EST 2001 | micah
Can anyone recommend a good software package which can be used to create panel criteria from Gerber/Cad data. Needs to do more than step & repeat. Need to be able to define panel size, add panel fiducials, define breakaways and hole sizes, ability
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too
Electronics Forum | Fri Nov 17 03:41:38 EST 2023 | ravikumargv
Dear All, Any update for the below request. Please do the needful as soon as possible
Electronics Forum | Tue Nov 17 20:36:54 EST 2020 | williamaxler
I have the original Cad2Cad software that was free from Assembleon. I can send it to you. I would need an email address.
