Electronics Forum | Fri Apr 02 10:55:00 EST 1999 | Scott McKee
| Does anybody put QFP's on the backsides of boards? Can they be reflowed without falling off? Do you use adhesive? | I've seen QFP's on the backside and yes, they need glued prior to reflow - just a couple of drops on the corners. Scott
Electronics Forum | Tue Oct 30 06:20:58 EDT 2007 | aj
Hi All, I would appreciate some advise with regard to Leadfree settings for a 5 zone reflow oven. I have a 35mm square BGA 672 pin on board. I am struggling to get the Delta T down to 2 degrees C . I have 5 Thermocuples drilled up from the bottom a
Electronics Forum | Wed Apr 07 14:43:27 EDT 1999 | Dick Casagrande
| | Does anybody put QFP's on the backsides of boards? Can they be reflowed without falling off? Do you use adhesive? | | | I've seen QFP's on the backside and yes, they need glued prior to reflow - just a couple of drops on the corners. | | Scot
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Fri Jun 14 14:25:05 EDT 2002 | davef
Good job clarifying things. So, your MELF are just rolling off the pads. So much for the rocket scientist that talked you into those �V� shaped apertures, eh? [Or taking it the other way: Wow, just think how bad it would be if they weren�t worki
Electronics Forum | Mon May 31 15:09:56 EDT 1999 | JohnW
| | | | | | | | I have always thought it to be a good practice to wash SMA's with water soluble paste (WS609) soon after reflow. Is there a time limit as to how long a board should sit after reflow before washing said board? For instance; processi
Electronics Forum | Mon May 31 15:10:14 EDT 1999 | JohnW
| | | | | | | | I have always thought it to be a good practice to wash SMA's with water soluble paste (WS609) soon after reflow. Is there a time limit as to how long a board should sit after reflow before washing said board? For instance; processi
Electronics Forum | Mon Apr 26 17:32:32 EDT 1999 | Scott McKee
| Hey Guys! | | Look what I get to try and do this week! I got handed a cardboard box on Friday afternoon with the parts and 20 of these little jewels! That's both sides of the board by the way... | | Whoever laid this out, I'd like to go and do a
| 1 |
