Electronics Forum | Wed May 16 13:55:25 EDT 2001 | davef
Urethane and parylene have the best long term humidity resistance of the conformal coatings. Since yer not hep about urethane, try the parylene [http://www.paratronix.com/apps/, http://www.paryleneinc.com/, http://www.parylene.com/, http://www.scsco
Electronics Forum | Wed Dec 12 12:08:30 EST 2007 | realchunks
Yes, you can ask for scrap boards, buy Dummy boards/parts or engineer off past runs. For this cost, I would profile, profile, profile. I would make/buy a dummy board. If you don't have one this thick, glue/ adhesive/ bolt some scrap boards togeth
Electronics Forum | Thu Feb 09 10:13:37 EST 2017 | swag
Agreed. We machine all our pallets in coolant. No dust but a big mess still results in the bottom of the CNC. You'll burn through a thousand cutters if you try it on a router table. Just doesn't seem feasible. You'd have to take like 0.020" dept
Electronics Forum | Tue Oct 11 05:52:04 EDT 2005 | GS
I know this could not be an SMT thread, but in certain way it impacts the PCB/PCBAs Assemblers. Hello everybody, who could help me please to identify if this tool Mmust be or Not compliant with the WEEE and ROHS Eu Directives ? I can define
Electronics Forum | Mon Mar 24 09:09:40 EDT 2008 | jdumont
Hello all, we have been seeing a lot of issues with broken or open vias on a couple of our bare boards. We have two vendors make these for us and the issue is only with one vendors boards. We have stopped using them until we can figure out what is go
Electronics Forum | Fri Mar 16 10:04:41 EDT 2012 | davef
We'd repair a drop board like this. Here's what our old friend Jeff Ferry said is a published article ... When boards lose their edge: when the corner of a circuit board breaks or is damaged, the problem cannot be ignored by Jeff Ferry One of the m
Electronics Forum | Mon Jan 04 23:22:33 EST 1999 | Steve Evers
| Does any one have some information on Sony routing machines? Do you know the website, the contact? Thanks. | As in PCB depaneling? The last two Sony integrated lines I saw were using the new patented Die Cutting depaneling technique, not routers.
Electronics Forum | Wed Jan 06 03:40:47 EST 1999 | Ken Mok
| | Does any one have some information on Sony routing machines? Do you know the website, the contact? Thanks. | | | As in PCB depaneling? | The last two Sony integrated lines I saw were using the new patented Die Cutting depaneling technique, not r
Electronics Forum | Wed Feb 09 10:34:19 EST 2005 | Ron
Is anyone currently reflowing a board with SC44 devices on it. This is a 6pin SAW filter with castellated terminations. I'm looking for a solder paste design for this part. I currently use a laser cut 6mil thick stencil.
Electronics Forum | Thu Dec 18 13:07:50 EST 2014 | kevinb
I have worked with Epoxy Technology in the past with silver epoxy. Just to fill you in on what I have been doing with this project in the past. I was using a silver epoxy for my 0201s. I then over molded with an epoxy with a dam and fill. Then th