Electronics Forum | Thu Jul 26 19:00:34 EDT 2012 | aex
Weird question, but I need it for a claim. About how long does it take to assemble, plug in the power and dry cycle a DEK 248 with vision. I'm saying 90 minutes to two hours tops. Additional opinions would be greatly appreciated.
Electronics Forum | Thu Aug 09 23:18:15 EDT 2012 | dekhead
Depends on to what degree it has been disassembled; How much verification of repeatability is required; and if everything actually works... 2 hour - 2 days.
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Sun Oct 21 22:05:01 EDT 2018 | srini1904
Hello, We have Dek 248 Icon i2 semi auto screen printer. This machine was not in use for long time and Bios battery was dead. We replaced Bios battery and now date are correct. Issue is its not communicating to control board. Suspecting Bios setti
Electronics Forum | Sat Feb 27 16:47:35 EST 2021 | petter
Looks like it was the diode inside the encoder. Are getting a new printer instead. Did a short time fix, connected a power supply to the motor and controlled the speed that way.
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Sat Nov 06 06:41:11 EDT 2021 | ttheis
The DEK248 we had at one time was pretty compact but it did not have automated alignment- just a semi-manual camera/monitor stencil alignment process.
Electronics Forum | Mon Jul 29 08:21:54 EDT 2002 | pjc
All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China (past 6 mos.?). Thats the fact Jack. All MPM models are built in Mass. Its the savings in
Electronics Forum | Mon Jul 29 08:28:05 EDT 2002 | pjc
Start killing DEK now, on the ELA. All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China, since 01 some time. Thats the fact Jack. All MPM mod