Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Sat Sep 22 20:20:13 EDT 2012 | dekhead
You don't say which 265; presumbly since you say "bulb" it is either MK1 or GS with shuttered camera. Both those machines have potentiometers to control light levels. MK1 is on machine frame inside drop down (stencil load) door, near serial tag. GS
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Sun Mar 16 05:53:36 EDT 2008 | iantech
do any of you guys have a copy of the setup and calibration for an old DEk 265 LT I want to calibrate the camera and squeege. thanks Ian
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Fri Jan 31 09:04:07 EST 2020 | dekhead
Light level adjustment; direct and oblique lighting, upward and downward. Applicability depends upon which lighting modules are fitted to the camera.
Electronics Forum | Thu Oct 27 14:10:30 EDT 2016 | wkboyd
Our DEK printer camera dims as it moves during fiducial setup. Is there a fix for this?
