Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Mon Jan 17 15:34:38 EST 2005 | montec2000
Just a thought, but check to make sure you dont have a pickup offset in your pd or machine thats causeing your problem.
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Thu Mar 30 10:54:48 EDT 2017 | emeto
If you use the calibration plate and stencil, that should fix the problem. I think that you are not saving the result from the calibration test. Double check manuals and probably with DEK technician, but it sounds like you are missing a step.
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Sat Oct 12 10:00:51 EDT 2019 | dekhead
Can you put -0.5mm offset in "Reverse X Offset" to alleviate?
Electronics Forum | Thu Oct 10 20:10:44 EDT 2019 | dekhead
More information on "mis-print": degree, direction, repeatability? If it is a repeatable offset, there are individual print direction specific offsets available... Or is it possible that there are erroneous offsets applicable to print direction causi
Electronics Forum | Thu Jul 16 22:03:46 EDT 2009 | azhiker
Hello, We have a DEK 265 we will run our boards front justified with relation to the stencil, can anybody give me an offset that you are using to order your stencil when the image is in the front? Thanks
winsouce.jpg)
