Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Wed Aug 12 14:06:25 EDT 2015 | bnorton
We tried restoring the Machine Configuration, Mapping, and Calibration data from after the calibration done last year. The error was still present after the restore and restart.
Electronics Forum | Tue Aug 04 12:11:56 EDT 2015 | bnorton
OS/2 UIC version 3.2.3 Powerup seems to go OK until, while the GUI says ...initializing..., an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want t
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Wed Aug 12 17:41:15 EDT 2015 | edwaterfall01
Sorry for all the typos in the last message. As the machine was powered OFF for two weeks I would have expected a battery problem. Can you capture a Logicimm file and see what the file says before the heart beat messages?
.gif)
winsouce.jpg)