Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Thu Jul 18 12:45:49 EDT 2019 | dekhead
Lots of things it could be (basics first): E-Stop pressed. Connections within E-stop circuit (mostly Y4). Connection of SYSTEM switch back to Y4. E-stop relay. Do double pushbuttons toggle partial SYSTEM?
Electronics Forum | Wed Jul 24 15:29:33 EDT 2019 | weglimir
It came out that 24V relay switch in the power supply part was simply broken. When we fixed that - stop button was pressed, but we came to this conclusion eventually!
Electronics Forum | Sat Jul 20 07:40:51 EDT 2019 | kylehunter
I have a 265 horizon. I've noticed that if we wait more than a minute or so after that screen appears, it does the same thing you describe. It's like it goes to sleep and doesn't register the button. So maybe try watching the screen, and right as you
Electronics Forum | Tue Feb 28 11:07:41 EST 2006 | Chunks
Gel Flex works for Dek, just a slight modificaion. Works 100% better than any Grid type of system. We had missprints from Grid Lok and Form Flex - about every 5th or 6th board. Until we modified the Gels, we would take the time and some peelable s
Electronics Forum | Tue Feb 28 11:15:20 EST 2006 | billyd
In my last life we had pretty good luck with the Grid-lok system. Just not very good for extremely large boards, or very thin ones. (Tends to push thin ones up and bend them before the table rises. **On DEK printers, mind you) Form-flex was a nightma
Electronics Forum | Tue Feb 28 14:49:48 EST 2006 | vdizzle
Yep Grid-Lok sucks for thin boards. We have it set up in 4 Dek Horizon 01s. Grid-Lok is actually strong enough to snap really thin boards. Other than that, the system has been great, especially if you have to do 10-12 changeovers per line per shif
Electronics Forum | Tue Feb 28 09:22:12 EST 2006 | Mity-C
We have just had gridlock installed on 4 DEK screen printers. I agree that if it partially catches a component you will have misprints. In the same respect, if a hard pin is placed in the wrong location, you will get misprints and or damaged componen
Electronics Forum | Mon Apr 07 17:54:10 EDT 2008 | pjc
yes, should have said "studies have shown"... as they do. if not, all would be using pump print heads on our DEKs and MPMs that can take them, aye?
