Electronics Forum | Thu Dec 12 10:20:00 EST 2013 | kkay
We are currently looking into purchasing the Dek vector guard system and would like any feedback from current users. Does the system hold up over time and does it break down often? Any info would be great!
Electronics Forum | Tue Dec 17 18:11:26 EST 2013 | swag
We've got a couple, never had a problem in 2 years. We like them.
Electronics Forum | Fri Dec 13 11:28:47 EST 2013 | island2013
I've used the DEK Vector Guard system in the past. We had three of them and we did alot of change overs. They held up really well and our stencil storage went from rack upon rack upon rack to a very small space. It was worth the money and the perf
Electronics Forum | Wed Jun 04 09:46:09 EDT 2008 | jseagle
We currently use the VectorGuard stencils and love them. They are so easy to set and remove from the frame and weigh almost nothing. We get very good prints, we do 0402 and 16mil. We previously tried the Tetra system and were not happy due to the
Electronics Forum | Tue Jun 03 17:53:21 EDT 2008 | pms
Anyone out there using this system ? We have been using the older DEK Vectra system. I don't like it, never did, but do like the small storage footprint, and are stencil supplier is showing signs that this system is gonna be obselete in the near fut
Electronics Forum | Tue Jan 26 14:30:44 EST 2021 | domgal
Hi, I'm looking for Sheets like DEK use for their Cabinet. we Need this Kind of Steel runners. Do you know any Distributor in Europe? DEK only sell the Cabinet itself. Kind Regards
Electronics Forum | Wed Dec 18 07:22:23 EST 2013 | davlec
We have not tried VectorGuard, so I cannot comment on that specific solution. However we have been using a Tecan Genesis system for several years and are very pleased with it. Unlike the DEK solution, the tensioning is entirely mechanical so there is
Electronics Forum | Thu Dec 12 13:52:55 EST 2013 | emeto
Vector guard is ok. Advantage is the space you save on stencils. We have 6 frames - I had to repair some of them through the years of usage - basically some of the tubes inside warn out and have to be replaced. Of courcce they have some mechanical li
Electronics Forum | Wed May 02 22:40:59 EDT 2007 | KEN
What is your opinion of this frameless system? How long have you had your system? How many cycles on your stencils? Any issues you are not happy with? How is storage working for you? Any issues with cleaning?
Electronics Forum | Fri Dec 13 06:41:36 EST 2013 | cbeneat
We also have 4 frames,been using them for a couple years. just had to change a line yesterday. Easy to do, as long as you have the repair kit. Much easier than a QTS frame.
.gif)
winsouce.jpg)