Electronics Forum | Tue Mar 08 11:50:55 EST 2011 | pgoodyear
As a technician that does frequent board level repair / rework some issues have come to mind. I have been an electronics technician for almost 50 years. In that time I have seen the evolution of electronics from point to point wiring using vacuum
Electronics Forum | Mon Jun 18 10:30:16 EDT 2001 | marys
What determines the cost of X-Ray Inspection?
Electronics Forum | Mon Sep 25 17:14:40 EDT 2000 | LarryK
Greg, Its an open ended question your asking here. What are you trying to do? Determine if your equipment is able to do what you need? E Determine your floor spacing? Determine what, if any, inspection equipment is needed? Determine constraints/line
Electronics Forum | Wed May 16 14:18:52 EDT 2001 | davef
Cal please help me understand your point better. How does the assembly determine the torque requirements? Are you saying that you expect the assembly drawing to contain a torque specification? If not, how do you determine the torque from the assem
Electronics Forum | Mon Dec 28 17:37:18 EST 1998 | Joann Moore
I am looking for a questionaire/list of items that need to be addressed to determine the pros/cons and equipment, manpower, cost and lead time to determine if one should consider setting up an in-house SMT line. Can anyone help? thanks
Electronics Forum | Sun Apr 05 11:42:36 EDT 1998 | Peter Guadagnin
Question: Whatparameters are used to determine "good" Solder Paste? What reference documents could be reviewed to determine good (acceptable) quality?
Electronics Forum | Tue Jan 22 20:27:28 EST 2002 | davef
Doesn't sound good does it? Consider using your field meter to determine the charge level generated in handling these connectors. Then you can determine the impact of the charge generated and the best handling approach.
Electronics Forum | Thu Aug 22 05:27:42 EDT 2002 | zolasteven
Hi, With regards to reflow oven or furnace, when conducting a temperature profile how does one determine how many points(Parts) on the pcboard to be measured/connected to the temperature profile. And how to determine what parts to measure? Than
Electronics Forum | Fri Sep 27 08:36:27 EDT 2002 | alewis
We are a manufacturer of placement machines and I believe that you asked if there was a reference that can be used to determine the tape sizes for most SMD packages. We review the catalogs from Practical Components and Top Line to determine tape size
Electronics Forum | Tue Apr 29 12:18:01 EDT 2003 | jgregory
Pete, I have to disagree with your statement regarding 3D Xray not being a good source of determining solder volume. The Agilent 5DX is absolutely fantastic at determining volume. However, cost of the system makes it not very practical. Jason
.gif)
