Electronics Forum | Tue Feb 09 14:32:04 EST 2021 | bobpan
You have to disable some lines in the machine.cfg file. If you do this....save the original before modifying it. I think you disable the gantry/head and the mei for Gantry 2.
Electronics Forum | Sat Apr 22 09:25:34 EDT 2017 | westshoredesign
> Database In... is disabled. The manual specifies this option will be disabled if network database option is on. However, it's not currently on, so I'm wondering how I can re-enable the "Database In..." option.
Electronics Forum | Wed Jun 07 04:48:35 EDT 2017 | dentata911
Hello Is it possible to disable CyberOptics align system. Not for single pickUp. Disable and disassemble from machine. Thank you.
Electronics Forum | Tue Dec 21 16:59:59 EST 2021 | tey422
You should able to log into the TPsys to disable the hydra head. BTW, last time I work on the Mydata machine was about 15years ago.
Electronics Forum | Fri Mar 24 12:57:08 EST 2006 | wbartley
It sounds like a theta problem, you could have a bad theta motor or driver. Does this happen during warm up? And you can try and disable one head at a time and optimize your program after each head is disabled and then run your program. To see if you
Electronics Forum | Fri Mar 02 11:26:17 EST 2007 | ausajid
hi thank you very much for your advice. there was only one option i beleive that should work, i have tried that option today, but still the machine goes to the alternate carrige instead of alternate feeder. the option was in operation mode, alternat
Electronics Forum | Sun Dec 25 17:35:06 EST 2005 | Mika
No camera re-calibration is required. Just don't load the deafult calibration parameters. /
Electronics Forum | Mon Feb 11 17:19:37 EST 2008 | slthomas
Don't forget to mention Repetitive Stress Syndrome and short term disability claim costs.
Electronics Forum | Wed Sep 02 08:03:24 EDT 2009 | kircchoffs
disable windows firewall
Electronics Forum | Tue Feb 09 14:53:50 EST 2021 | jamesn
Thank you bobpan much appreciated I will give it a go Regards James
