Electronics Forum | Wed Jun 21 22:07:09 EDT 2000 | Jason
We are going to try double sided reflow for the first time. Can we use the same 63/37 paste on both sides? The board also has bare copper pads i'm pretty sure. will this present any challenges? The bottom side has a QFP on it. Should it stay on?
Electronics Forum | Tue May 14 21:07:03 EDT 2002 | ianchan
Hi mates, Yes, the lighter mass is a valid reasoning. in addition to the "lighter (mass) than thou" point of view, 1) the first reason for mounting active Parts (eg. IC, QFP, LGA...) is to minimize the temperature exposure of the Parts to a single
Electronics Forum | Tue Mar 15 22:04:56 EST 2005 | KEN
The hasl joint looks fuller (and is easier to inspect)because it has more solder volume. Think about it. Your pre-plating your board with solder (before you add more solder). I doubt your getting 0.3 mils of hasl.....probably more like 1.3 to 3.0
Electronics Forum | Wed Mar 14 17:33:42 EST 2001 | davef
Check Bob Willis' site. He calls this Single Side Multipass Endothermic Elongated Happy Reflow Soldering, er someting like that. Ha ha ha!!! Naw, he calls it Simultaneous Double-Sided Reflow Soldering. That might be something like you are talking
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Tue Mar 03 03:38:46 EST 2020 | toki
Hello everyone, I would like to know what is the current trend in SMT line setup in terms of assembling both side pcbs at one go. Is it dual lane or single lane double line set up? Thanks
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Wed Mar 04 03:32:55 EST 2020 | tamasmagyar
Hi toki, First of all it depends on how much the company would like to invest in such a methodology. Second of all, why would you make a line to be single lane - double line one after each other, is that automotive / medical standard, not to handle
Electronics Forum | Fri Aug 13 10:19:35 EDT 1999 | Boca
| | We are using a mixed technology process with mostly through-hole parts plus some SMT IC's on the component side and some passive SMT parts on the solder side. We do not have a proper wave soldering machine for doing solder side SMT (double wave
Electronics Forum | Wed Aug 11 15:58:39 EDT 1999 | Doug Philbrick
| We are using a mixed technology process with mostly through-hole parts plus some SMT IC's on the component side and some passive SMT parts on the solder side. We do not have a proper wave soldering machine for doing solder side SMT (double wave or
