Electronics Forum | Tue Oct 11 11:52:58 EDT 2005 | chunks
Elektrobit (JOT) makes a wave unloader you can use to put your board back onto an edge conveyor (if you are using just a belt on your oven now) and then place a FIFO or Mag Loader after that.
Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch
Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)
Electronics Forum | Tue May 25 17:29:10 EDT 2010 | wendyjacobs
I need help. I recently purchased a used Dynapace Wave Exit Conveyor, model # C17697, at auction. The conveyor arrived with no user manual. I need a password to program it and Dynapace is no longer in business. Does anyone know or can suggest a d
Electronics Forum | Wed Dec 17 13:04:37 EST 2003 | Bill
Thanks for the information, --We would like to replace the conveyor 'belt' rather than replace the whole conveyor. Do you know of any sources for the belting material? (ESD, heat and chemical resistant) Best Regards, Bill
Electronics Forum | Wed Dec 17 14:08:42 EST 2003 | davef
Really, they wouldn't sell you just the belt??? Wow. Oh well, there was a SMTnet Thread on conveyor belts within the past 3 months. Search the fine Archives.
Electronics Forum | Wed Dec 17 13:20:43 EST 2003 | fdr4prez
I was under the impression that PCT was bought out by one of their competitors, but I can't remember who. This was a couple years ago. You may need to call a few manufacturers, or do some more research to see who bought them.
Electronics Forum | Wed Dec 17 14:27:57 EST 2003 | Pete C
FlexLink purchased PCT Automation Systems Corp. http://www.flexlink.com/
Electronics Forum | Tue Dec 16 16:14:20 EST 2003 | Bill
We are in need of a replacement conveyor belt for an unload-end conveyor(post wave solder). The part number we had at one point (formerly PCT automation) was 65-4008-4 (Belt, Flat-W=23.75 L=171.70) green high temp conveyor belt. Any help would be g
Electronics Forum | Fri Dec 19 10:15:24 EST 2003 | haviland
Bill--Good morning. We have several decline conveyors w/ conductive black belt Plus cool down units w/ banks of (8) fans. I believe the belt widths are 18". Would that work? Everything is in Illinois. Thanks, Nick Haviland, Electronic Assembly Machin
Electronics Forum | Tue Dec 16 17:30:05 EST 2003 | davef
Tech-Mation International 952 Alton Parkway Irondale, Al 35210 205-833-4277 (fax) 4377 Phil Higgins, Mathew Bennett (sales) Eric Ford (sales) tiusa@bellsouth.net http://www.tech-mation.com We have no relationship, nor receive benefit from the comp
winsouce.jpg)
