Electronics Forum | Sun Oct 31 03:46:34 EDT 2021 | earesearch
Hello, I currently have several csm7100, csm7000plus and pantera xv from essemtec. I wanted to see if anyone here was interested in training per hour or job. I have another friend who also has a csm7000 and needs some assistance in a few areas to g
Electronics Forum | Fri Feb 01 13:09:16 EST 2013 | emeto
I am glad you got it. It had to be one of these.
Electronics Forum | Sun Feb 03 07:41:29 EST 2019 | dfl
Anyway, after both procedures, the feeder still advancing more than 4mm (like 12mm or so)
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sat Feb 02 09:53:49 EST 2019 | slthomas
Commponent pitch programming is performed via the buttons on the feeder. I don't remember enough to walk you through it but there are people here that do - I'm sure you'll get some help shortly. If not, go to http://www.precision-repairs and use th
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
Electronics Forum | Wed Jan 30 11:27:44 EST 2013 | ericrr
----- More ------ Due to the need to keep to run going while waiting fo the repair joker to emerge, are doing the run on just two machines.It turns out that when the faulty machine has been left on for two hours the fault disappears and the machine w
.gif)
